Muse Research Receptor support - updates and software downloadsReceptor Update InformationIMPORTANT: Receptor System Software updates can be installed over the immediately preceding major version ONLY. For example, if you wish to update a Receptor 1 from version 1.2 to version 1.7 you would need to download and install versions 1.3, 1.4, 1.5 and 1.6 first and install each one individually, following the instructions below, before installing version 1.7. Receptor 1 Downloads
Receptor Tools Downloads
Miscellaneous DownloadsNative Instruments Service Center
Please note that it may already be pre-installed on your Receptor if it left the factory after October 2007. Receptor Update InformationIMPORTANT: Receptor System Software updates can be installed over the immediately preceding major version ONLY.
Receptor System Update ProcedureBackup Banks & Patches Before updating Receptor you should copy any user patches to a local computer, as a precaution. The location of these files are listed below. <Receptor hard drive> refers to Receptor's hard drive as it shows up on your computer (i.e. in Windows Explorer or Mac OS X Finder).
Update Installation Instructions Before updating your Receptor please verify which version of the system is currently installed. You can check this on the SETUP screen on the Graphical User Interface (GUI) or from the Front Panel -> press the SETUP button on the Front Panel; turn the top display knob until you see "SU System Version". If it is not the immediately preceding major version to the one you are updating to (e.g. if you are updating to v1.7 the Receptor must have at least 1.6 installed) please download and update each major version in order, following the instructions below for each one.
DO NOT TURN OFF RECEPTOR DURING THE UPDATE PROCESSNote: The installation process may take several minutes to complete. When Receptor starts rebuilding it cache the Front Panel will be blank, just wait it out, that's the last step before the host application loads. If the updater fails to install (i.e. it shows as Installation Failed on the front panel or 'Failed' on the SETUP tab on screen), please review "step 1" and verify that your Receptor was already running the immediately preceding major version to the one you are updating to (e.g. if you are updating to v1.7 the Receptor must have at least 1.6 installed). |